Indicators during sending/receiving operation, Responding to an attention indicator flashes – Kyocera FAX System 12 User Manual

Page 225

Advertising
background image

11-2

Troubleshooting > Indicators During Sending/Receiving Operation

Indicators During Sending/Receiving Operation

The [Processing] and [Memory] indicators show the fax transmission status.

• The [Processing] indicator blinks during fax transmission and reception.

• The [Memory] indicator blinks when source data is being stored in memory for memory transmission.

• The [Memory] indicator is lit when there is source data stored in the memory for delayed transmission.

Responding to an Attention Indicator Flashes

If the [Attention] indicator flashes, select the [Status/Job Cancel] key to check an error message. If the message is not
indicated on the touch panel when the [Status/Job Cancel] key is pressed or the attention indicator flashes, check the
following.

Symptom

Checkpoints

Corrective Actions

Reference

Page

Cannot send fax.

Is the modular cord
connected correctly?

Connect the modular cord correctly.

Is Permitted FAX No. or
Permitted ID No. registered
correctly?

Check Permitted FAX No. and
Permitted ID No.

8-15

Has a communication error
occurred?

Check error codes in the TX/RX
Result Report and Activity Report. If
the error code starts with "U" or "E",
perform the corresponding
procedure.

11-6

Is the destination FAX line
busy?

Send again.

Does the destination FAX
machine respond?

Send again.

Is there an error other than
above?

Contact your Service
Representative.

Advertising