ProSoft Technology PLX8X-MNET-61850 - Manual (Page 113)

PLX8x-MNET-61850 ♦ Communication Gateway Diagnostics and Troubleshooting
Modbus TCP/IP to IEC 61850 User Manual
ProSoft Technology, Inc. Page 113 of 228
May 14, 2014
Ethernet Statistics
Function Description
RX Bytes Total received byte count
RX Packets Total number of received Ethernet packets
TX Bytes Total number of transmitted bytes
TX Packets Total number of transmitted Ethernet packets
Jumper States
Jumper Name States Description
Setup ON or OFF This is the top jumper in the
back of the gateway
Default IP ON or OFF This is the middle jumper
Reserved ON or OFF This is the bottom jumper. It is
reserved for internal ProSoft
Technology use
LED States
State Description
Error ON or OFF. This is the "ERR" LED above the power connector
Config ON or OFF. This is the "CFG" LED above the power connector
Fault ON or OFF. This is the "FLT" LED above the power connector
ms OFF. This is not used by PLX8X-MNET-61850
ns OFF. This is not used by PLX8X-MNET-61850
Network Configuration
Function Description
IP Address This is the gateway’s configured IP address set by the user in ProSoft 61850
Configuration Manager.
Network Mask This is the gateway’s configured network mask, set by the user.
Gateway This is the ProSoft Gateway’s configured gateway, set by the user.
Operation Mode
Values may be:
o Init
o Start
o Ready
o Run
o Stop
o Restart
o Shutdown
o Done