ProSoft Technology PLX8X-MNET-61850 - Manual (Page 15)

PLX8x-MNET-61850 ♦ Communication Gateway Start Here
Modbus TCP/IP to IEC 61850 User Manual
ProSoft Technology, Inc. Page 15 of 228
May 14, 2014
1.4 Jumper States
There are three sets of jumper settings located on the back of the module.

MODE 3 - Development Mode Jumper: (Top Jumper) Used for firmware
updates only. The two pins should NOT be jumpered during normal
operation.

MODE 2
– Default IP Jumper: (Middle Jumper) The default IP address
of the ProSoft gateway is 192.168.0.250. Set this jumper to put the
gateway's IP address back to the default. The two pins should NOT be
jumpered during normal operation.

MODE 1 – (Bottom Jumper) Reserved