ProSoft Technology PLX8X-MNET-61850 - Manual (Page 3)

Important Installation Instructions
Power, Input, and Output (I/O) wiring must be in accordance with Class I, Division 2 wiring methods, Article 501-4 (b)
of the National Electrical Code, NFPA 70 for installation in the U.S., or as specified in Section 18-1J2 of the Canadian
Electrical Code for installations in Canada, and in accordance with the authority having jurisdiction. The following
warnings must be heeded:
WARNING - EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS MAY IMPAIR
SUITABILITY FOR CLASS I, DIV. 2;
WARNING - EXPLOSION HAZARD - WHEN IN HAZARDOUS LOCATIONS, TURN OFF
POWER BEFORE REPLACING OR WIRING MODULES
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT UNLESS POWER
HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO BE NON-HAZARDOUS.
THIS DEVICE SHALL BE POWERED BY CLASS 2 OUTPUTS ONLY.
Product Warnings
WARNING – EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENT UNLESS
POWER HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO BE NON-HAZARDOUS.
AVERTISSEMENT
– RISQUE D'EXPLOSION – AVANT DE DÉCONNECTER L'EQUIPMENT,
COUPER LE COURANT OU S'ASSURER QUE L'EMPLACEMENT EST DÉSIGNÉ NON
DANGEREUX.
Battery Life Advisory
The Prosoft Gateway uses a non-rechargeable lithium (lithium carbon monofluoride chemistry)
battery to back up the real-time clock and CMOS. The battery should last for at least 10 years
when stored. The battery is not used nor being recharged during its operation.
Note: The battery is not user replaceable.
Agency Approvals & Certifications
ATEX <Ex> II 3 G Ex nA II T5 0 °C <=
Ta <= +60 °C
cULus
0

C to +60

C
Temperature Code – T5
CB Safety
CE