GeoVision GV-AS2120 IP Control Panel - Manual (Page 156)

154
[ID]
Enter the ID number for the controller. This ID is used by GV-ASManager to differentiate
among multiple units of controller. ID number can only be between 1 and 1000.
[Door/Gate #] [Elevator]
Select the function type and authentication mode for the use of the Doors/Gates. For GV-
EV48, select an authentication mode to apply to all floors of the elevator.
◼ Function:
Select the function for the reader connected to the Door/Gate.

Door Control:
The reader is installed in a general door for access control.

Parking Control:
The reader is installed in a parking place for access control.
 Elevator Control:
The reader is installed in an elevator for access control.
◼ Authentication Mode:
Select the authentication mode for the Doors/Gates or Elevator.
 Local Unlock Mode:
Remains open. The held-open state cannot be cleared
through GV-ASManager.
 Local Lock Mode:
Remains locked. The locked state cannot be cleared through
GV-ASManager.
 Fixed Card Mode:
Grants access after the card is presented or the passcode is
entered, and ignores the authentication schedule of GV-ASManager.
 Fixed Card + PIN Mode:
Grants access after the user presents the card and enters
the card’s PIN code, and ignores the authentication schedule of GV-ASManager.

Fixed Card/Common mode:
Grants access after the user presents the card or
enters the door’s password, and ignores the authentication schedule of GV-
ASManager.
 Authentication Schedule Mode:
Follows the authentication schedule set on GV-
ASManager.

Local Lock Down:
Locks down the door. This mode overrides the Authentication
Schedule and the door can only be opened by presenting the assigned access card.
This function is only available in GV-AS1010 / 1110.