GeoVision GV-AS2120 IP Control Panel - Manual (Page 208)

206
[Alarm]
Select
Yes
or
No
to enable or disable the alarm function. If you have defined the alarm
conditions in [Output Function] of the
In/Out Function
page (Figure 9-23), remember to
activate the corresponding alarms here; otherwise, even though the alarm conditions are
met, the expected alarm will not be triggered. The default settings for all the alarms are set
to
NO
.
Figure 9-18
• When
Door Entry/Exit Control
or
Parking Entry/Exit Control
is selected in the
Function Setting
page (Figure 9-15), these options become available:
Option Description
Held Open This alarm activates whenever the door is held open over the set
period of time.
Forced Open This alarm activates whenever the door is opened by force.
Fire Alarm This alarm activates whenever fire is detected.
Access Denied This alarm activates whenever entry is denied due to using the
wrong card or entering the wrong password.
Tamper This alarm activates whenever the controller is being physically
tampered with, e.g. opening of the controller or sustaining strong
impact. GV-AS100 / 110 / 120 have built-in sensors for tampering
alarm.
• When
Elevator Control
is selected in the
Function Setting
page (Figure 9-15), these
options become available:
Option Description
Fire Alarm See the same option above.
Access Denied
Tamper