GeoVision GV-AS2120 IP Control Panel - Manual (Page 182)

180
[GeoFinger Server IP Address]
To allow GV-ASManager to receive data from the GV-
GF1921 / 1922 defined on this page during remote fingerprint enrollment, type the IP
address and port of the GV-ASManager’s GeoFinger Server. You can also complete this
step on the Web interface of each GV-GF1921 / 1922 individually as shown below.
Figure 8-27
[GF1901 / GF1902 / GF1911 / GF1912 Function]
Define GV-GF1901 / 1902 / 1911 / 1912
connected to the controller.
• GV-GF1901 / GF1902:
Select the
RS-485
checkbox and type the
XID Number
located
on the back of the reader.
• GV-GF1911 / GF1912:
Select the
RS-485
checkbox only if the GV-GF1911 / 1912 is
connected to the controller through RS-485. If the reader is using network connection, do
not check the RS485 box. Type the
XID Number
located on the back of the reader.
Click
Submit
. If the reader is detected, the
Connection Status
field will be green.
Note:
To connect GV-GF1901 / 1902 / 1911 / 1912 through RS-485, the firmware of GV-
AS21 / 41 / 81 series Controller must be before 1.4.1, and the software version of GV-
ASManager must be before V4.4.3.