Preset speed #3 on pg. 101, Preset speed #4, Preset speed #5 – Toshiba W7 User Manual
Page 107: Preset speed #6, Preset speed #7, Preset speed #3
W7 ASD Installation and Operation Manual
101
Preset Speed #3
Program
⇒
Preset Speeds
⇒
3
This parameter assigns an output frequency to binary number 0011 and is
identified as Preset Speed #3. The binary number is applied to S1 – S4 of the
Control Terminal Strip to output the Preset Speed (see
for
further information on this parameter).
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit
Maximum — Upper Limit
Units — Hz
Preset Speed #4
Program
⇒
Preset Speeds
⇒
4
This parameter assigns an output frequency to binary number 0100 and is
identified as Preset Speed #4. The binary number is applied to S1 – S4 of the
Control Terminal Strip to output the Preset Speed (see
for
further information on this parameter).
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit
Maximum — Upper Limit
Units — Hz
Preset Speed #5
Program
⇒
Preset Speeds
⇒
5
This parameter assigns an output frequency to binary number 0101 and is
identified as Preset Speed #5. The binary number is applied to S1 – S4 of the
Control Terminal Strip to output the Preset Speed (see
for
further information on this parameter).
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit
Maximum — Upper Limit
Units — Hz
Preset Speed #6
Program
⇒
Preset Speeds
⇒
6
This parameter assigns an output frequency to binary number 0110 and is
identified as Preset Speed #6. The binary number is applied to S1 – S4 of the
Control Terminal Strip to output the Preset Speed (see
for
further information on this parameter).
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit
Maximum — Upper Limit
Units — Hz
Preset Speed #7
Program
⇒
Preset Speeds
⇒
7
This parameter assigns an output frequency to binary number 0111 and is
identified as Preset Speed #7. The binary number is applied to S1 – S4 of the
Control Terminal Strip to output the Preset Speed (see
for
further information on this parameter).
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit
Maximum — Upper Limit
Units — Hz