Toshiba W7 - Manual (Page 82)

76 W7 ASD Installation and Operation Manual
F Terminal Delay
Program ⇒ Terminal Settings ⇒ Terminal Delays ⇒ Input Terminal
Delays ⇒ F
This parameter delays the response of the ASD to any change in the F terminal
input by the programmed value.
The delay may be increased to provide additional electrical noise immunity or
to prevent the ASD from responding to contact bounce or chatter.
Parameter Type — Numerical
Factory Default — 8.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Hz Per User-defined Unit
Program
⇒
Utilities
⇒
Display Attributes
⇒
Hz Per User Defined Unit
This parameter allows the user to input a quantity to be displayed on the EOI
that is proportional to the output frequency of the drive.
This feature is useful when the output of a process is moved along at a rate that
is proportional to the output frequency of the drive.
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.0
Units — Hz/UDU
Input Feedback Selection
Program ⇒ Feedback Settings ⇒ Input Feedback Selection
This parameter Enables/Disables PID feedback control. This parameter is
enabled by selecting a source for motor-control feedback.
Settings:
PID (Control) Disabled
VI/II
RR
RX
RX2 (option)
Parameter Type — Selection List
Factory Default — PID Disabled
Changeable During Run — Yes
F Terminal Delay Input Feedback Selection