Bin speed reference setpoint #1, Bin speed reference reference #2 – Toshiba W7 User Manual
Page 65
W7 ASD Installation and Operation Manual
59
BIN Speed Reference Setpoint #1
Program
⇒
Frequency Settings
⇒
Speed Reference Setpoints
⇒
BIN
⇒
BIN Speed Reference Setpoint #1
This parameter is used to set the direction, gain, and bias of the discrete input
terminals when using the discrete input terminals as the control input while
operating in the Speed Control or the Torque Control mode.
See
BIN Speed Frequency Setpoint #1
for further information on this setting
when used for Speed control.
See
BIN Torque Reference Reference #1
for further information on this
setting when used for Torque control.
This parameter sets the BIN input that is associated with BIN Speed
Frequency #1 when operating in the Speed control mode or is associated with
the BIN Torque Reference #1 when operating in the Torque control mode.
This value is entered as 0 to 100% of the binary input word 11111111 (255
D
).
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 100.00
Units — %
BIN Speed Reference Reference #2
Program
⇒
Frequency Settings
⇒
Speed Reference Setpoints
⇒
BIN
⇒
BIN Speed Reference Setpoint #2
This parameter is used to set the direction, gain, and bias of the discrete input
terminals when using the discrete input terminals as the control input while
operating in the Speed Control or the Torque Control mode.
See
BIN Speed Frequency Setpoint #1
for further information on this setting
when used for Speed control.
See
BIN Torque Reference Reference #1
for further information on this
setting when used for Torque control.
This parameter sets the BIN input that is associated with BIN Speed
Frequency #2 when operating in the Speed control mode or is associated with
the BIN Torque Reference #2 when operating in the Torque control mode.
This value is entered as 0 to 100% of the binary input word 11111111 (255
D
).
Parameter Type — Numerical
Factory Default — 100.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 100.0
Units — %