W7 asd direct access/communication numbers, W7 asd, Direct access/communication numbers on pg. 46 – Toshiba W7 User Manual

Page 52: Parameter name no. parameter name no

Advertising

W7 ASD Installation and Operation Manual

W7 ASD Direct Access/Communication Numbers

The W7 ASD has the ability to allow the user direct access to the motor control functions. The functions
listed below have an associated Parameter Number which accesses its setting. There are three ways in
which the motor-control parameters may be accessed for modification: Program

⇒

applicable menu path,

Program

⇒ Direct Access ⇒ applicable parameter number, or via Communications (see the 7-Series

Serial Communications User Manual for further information on communications protocol).

Once

accessed, the parameter may be viewed or changed.

The Program mode allows the user to develop

an application-specific motor control profile. Motor

control functions may be set to accommodate specific power and timing requirements for a given
application. The configurable parameters of the Program mode that have user-accessible Parameter
Numbers are listed and described below.

Note: The setup procedures included within this section may require a Reset before performing the

procedure. Application-specific settings may then be performed. The pre-Reset conditions may be
saved (see

Save User Parameters

Table 5. W7 ASD Direct Access/Communication Numbers.

Parameter Name

No.

Parameter Name

No.

Command Mode

0003

Preset Speed #4

0021