Toshiba W7 - Manual (Page 81)

W7 ASD Installation and Operation Manual 75
Frequency Mode #1
Program ⇒ Utilities ⇒ Command and Frequency Settings ⇒ Frequency
Mode #1 Select
The Frequency Mode (#1) setting establishes the source of the frequency-
control input for the ASD.
Settings:
Use VI/II
Use RR
Use RX
Use Option Card RX2
Use LED Keypad Option
Use Binary/BCD Input
Use Common Serial (TTL)
Use RS232/RS485
Use Communication Card
Use Motorized Pot. Simulation
Use Pulse Input Option
Parameter Type — Selection List
Factory Default — Use RR
Changeable During Run — No
Frequency Mode (#2)
Program ⇒ Frequency Settings ⇒ Reference Priority ⇒ Frequency
Mode #2
This parameter selects the source of the frequency command signal to be used
as Frequency Mode #2 in the event that Frequency Mode #1 is disabled or if
Frequency Mode #2 is set up as the primary control parameter.
See the Reference Priority Selection parameter for additional information on
this setting.
The Frequency Mode setting establishes the source of the frequency-control
input for the ASD.
Settings:
Use VI/II
Use RR
Use RX
Use Option Card RX2
Use LED Keypad Option
Use Binary/BCD Input
Use Common Serial (TTL)
Use RS232/RS485
Use Communication Card
Use Motorized Pot. Simulation
Use Pulse Input Option
Parameter Type — Selection List
Factory Default — Use RR
Changeable During Run — No
F Terminal
Program ⇒ Terminal Settings ⇒ Input Terminals ⇒ F
This parameter selects the functionality of the F discrete input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable F terminal to 1 of the 69 possible
functions that are listed in
Table 6 on page 138 .
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Frequency Mode #1 F Terminal