Rs232/rs485 communication time-out time, Rs232/rs485 communication time-out action, Rs232/rs485 baud rate – Toshiba W7 User Manual
Page 116
110
W7 ASD Installation and Operation Manual
RS232/RS485 Baud Rate
Program
⇒
Communication Settings
⇒
RS232/RS485 Baud Rate
This parameter sets the RS232/RS485 baud rate.
Changes made to this parameter require that the power be cycled (Off then On)
for the changes to take effect.
Settings:
1200
2400
4800
9600
19200
38400
Parameter Type — Selection List
Factory Default — 9600
Changeable During Run — Yes
RS232/RS485 Communication Time-Out Action
Program
⇒
Communication Settings
⇒
RS232/RS485 Timeout Action
This parameter plays a role in the setup of the communications network by
determining the action to be taken in the event of a time-out (Time-Out
Action).
The communications network includes other ASDs and Host/Control computers
that monitor the status of the ASD(s), transfers commands, and loads or
modifies the parameter settings of the ASD.
Changes made to this parameter require that the power be cycled (Off then On)
for the changes to take effect.
Settings:
None
RS232/RS485-Alarm – TTL-None
RS232/RS485-Trip – TTL-None
RS232/RS485-None – TTL-Alarm
RS232/RS485-Alarm – TTL-Alarm
RS232/RS485-Trip – TTL-Alarm
RS232/RS485-None – TTL-Trip
RS232/RS485-Alarm – TTL-Trip
RS232/RS485-Trip – TTL-Trip
Parameter Type — Selection List
Factory Default — 485-Alarm – TTL-
None
Changeable During Run — Yes
RS232/RS485 Communication Time-Out Time
Program
⇒
Communication Settings
⇒
485 Timeout Time
This parameter plays a role in the setup of the communications network by
setting the time that no activity may exist over the communications link before
the link is severed (Time Out).
The communications network includes other ASDs and Host/Control computers
that monitor the status of the ASD(s), transfers commands, and loads or
modifies the parameter settings of the ASD.
Changes made to this parameter require that the power be cycled (Off then On)
for the changes to take effect.
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 100
Units — Seconds