Rx2 speed reference setpoint #1, Rx2 speed reference setpoint #2 – Toshiba W7 User Manual
Page 120
114
W7 ASD Installation and Operation Manual
RX2 Speed Reference Setpoint #1
Program
⇒
Frequency Settings
⇒
Speed Reference Setpoints
⇒
RX2
⇒
RX2 Speed Reference Setpoint #1
This parameter is used to set the direction, gain, and bias of the RX2 input
terminal when the RX2 terminal is used as the control input while operating in
the Speed Control or the Torque Control mode.
See
RX2 Speed Frequency Setpoint #1
for further information on this setting
when used for Speed control.
See
RX2 Torque Reference Setpoint #1
for further information on this setting
when used for Torque control.
This parameter sets the RX2 input level that is associated with RX2 Speed
Frequency #1 when operating in the Speed control mode and is associated with
the
RX2 Torque Reference Setpoint #1
when operating in the Torque control
mode.
This value is entered as -100 to +100% of the -10 to +10 VDC RX2 input
signal range.
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -100.0
Maximum — 100.0
Units — %
RX2 Speed Reference Setpoint #2
Program
⇒
Frequency Settings
⇒
Speed Reference Setpoints
⇒
RX2
⇒
RX2 Speed Reference Setpoint #2
This parameter is used to set the direction, gain, and bias of the RX2 input
terminal when the RX2 terminal is used as the control input while operating in
the Speed Control or the Torque Control mode.
See
RX2 Speed Frequency Setpoint #1
for further information on this setting
when used for Speed control.
See
RX2 Torque Reference Setpoint #1
for further information on this setting
when used for Torque control.
This parameter sets the RX2 input level that is associated with RX2 Speed
Frequency #2 when operating in the Speed control mode and is associated with
the
RX2 Torque Reference Setpoint #2
when operating in the Torque control
mode.
This value is entered as -100 to +100% of the -10 to +10 VDC RX2 input
signal range.
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -100.0
Maximum — 100.0
Units — %