Heading2 - alarms, Alarms, Table 11 on pg. 147 – Toshiba W7 User Manual

Page 153: Eoi display function description possible causes

Advertising
background image

W7 ASD Installation and Operation Manual

147

Alarms

Table 11

lists the alarm codes that may be displayed during operation of the W7 ASD. Each alarm code

listed is accompanied by a description and a possible cause. In the event that the source of the malfunction
cannot be determined, contact your Toshiba Sales Representative for further information on the condition
and for an appropriate course of action.

The active Alarm is displayed on the Frequency Command screen. Multiple active alarms are displayed
one at a time and are scrolled at one-second intervals.

Table 11. W7 ASD Alarms.

EOI

Display

Function

Description

Possible Causes

CM1

Comm1 Error

Internal communications error.

• Improperly programmed ASD.

• Improper communications settings.

• Improperly connected cables.

CM2

Comm2 Error

External communications error.

EMG

Emergency Off

Output signal from the ASD is
terminated and a brake may be
applied if so configured.

• Stop|Reset pressed twice at the EOI.

• EOFF command received remotely.

• ASD reset required.

MOFF

Main
Undervoltage

Undervoltage condition at the

3-phase AC input to the ASD.

• Low 3-phase utility voltage.

OC

Over Current

ASD output current greater than
the parameter

0601

setting.

• Defective IGBT (U, V, or W).

• ASD output to the motor is connected incorrectly.

Disconnect the motor and retry.

• ASD output phase-to-phase short.

• The ASD is starting into a spinning motor.

• Motor/machine jammed.

• Mechanical brake engaged while the ASD is starting or

while running.

• Accel/Decel time is too short.

• Voltage Boost setting is too high.

• Load fluctuations.

• ASD operating at an elevated temperature.

*OH

Overheat

ASD ambient temperature
excessive.

• ASD is operating at an elevated temperature.

• ASD is too close to heat-generating equipment.

• Cooling fan vent is obstructed (see

Mounting the ASD

on pg. 18

).

• Cooling fan is inoperative.

• Internal thermistor is disconnected.

OJ

Timer

Run-time counter exceeded.

Type Reset required; select Clear run timer.

* Reset ignored if active.

Advertising