GE Industrial Solutions Galaxy Power Systems User Manual
Installation guide for galaxy power systems
Advertising
Installation Guide
Select Code 167-792-157
Comcode 108327362
Issue 12
August 2012
Installation Guide
for Galaxy Power Systems
Note: Instructions in this manual reference installation and setup of GPS
systems with Galaxy Millennium Controllers and 596 or 596 rectifiers.
For installation and setup with other controllers and rectifiers refer to
these product manuals.
GalaxyMillennium II Product Manual
167-792-181
GalaxyPulsar Plus Product Manual
CC848815341
NE Rectifiers
GPS2436 Product Manual
850022020
GPS4827 Product Manual
850022019
Advertising
Table of contents
Document Outline
- Installation Guide for Galaxy Power Systems
- Table of Contents
- List of Figures
- List of Tables
- Introduction
- Safety
- Getting Started
- System Electrical Architecture Overview
- Cabinet Floor Mounting and Battery Stand Connection
- Centralized or Distributed Architecture Connections
- AC Connection and Wiring
- DC Distribution Assembly and Connections
- Converters
- Remote Peripheral Monitoring
- Battery Connection Panels
- Thermal Probe and 210E Connections
- Introduction
- Cable Letter Codes
- Connecting Thermal Probe Cable Assembly
- Wiring Schematic for Extender Cable
- Cable Routing
- Connecting Thermal Probe Assembly
- Connecting a 210E Module to the Controller or BLJ Board
- Connecting Cable Assembly to the 210E
- Connecting Cable Assembly to Thermal Probes
- Monitoring a 210E Alarm Signal, BLJ-BIC7/8 with Millennium
- Fascia Cover Installation
- Connection of Office Alarms
- Power Up and Installation Completion
- Initial System Checkout and Preparation for Power Up
- Controller Front Panels
- Initial Power Up of the System
- Installing Rectifiers and Converters
- Lamp Test
- Voltage Calibration
- Setting the System Float Voltage
- Setting the System Shunt
- Setting the Low-Voltage Battery Disconnect Feature
- Setting the Low-Voltage Load Disconnect Feature
- Connecting Batteries
- Testing Rectifiers and Load Share
- Testing Temperature Compensation (Optional Feature)
- Testing Additional Alarms
- Testing the BD Alarm and High Voltage Shutdown
- Galaxy Millennium Controller System Alarm Test
- Connecting to Load
- Addition or Modification to a Galaxy Power System