Setting the cic id, Figure 9-3: setting the cic id switch – GE Industrial Solutions Galaxy Power Systems User Manual
Page 138
Advertising
Installation Guide for Galaxy Power Systems
9 - 4 Converters
Issue 12 August 2012
Setting the CIC ID
Setting the CIC ID
Step
Action
1
Remove the CIC card from the carrier. On the front side of
the CIC (component side), the cover is scored so that the
CIC ID switch may be exposed.
2
Set the ID switch to “1.” See Figure 9-3.
Figure 9-3: Setting the CIC ID Switch
3
Do not install the converter cards at this time. See Section
15.
Advertising