Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 171)

Brocade Mobility 7131N-FGR Product Reference Guide 159
53-1001947-01
Configuring IP filtering
5
a. Select Network Configuration -> Wireless from the Brocade Mobility 7131N-FGR Access
Point menu tree.
b. Click the Create button to apply the filter to a new WLAN, or highlight an existing WLAN and
click the Edit button. Either the New WLAN or Edit WLAN screen displays.
c. Select the Enable IP Filtering button in the lower portion of the screen.
d. Select the IP Filtering button.
The screen displays with both the Default Incoming Deny and Default Outgoing Deny
checkboxes selected by default. Consequently, if you enable IP filtering but do not apply any
filters that allow IP traffic, then no IP traffic will be forwarded, as the default deny settings have
precedence.
2. Use the Filter name drop menu to select an existing filter.
3. Set the Direction as Incoming or Outgoing as required.
4. Apply an Action of Allow or Deny to permit or restrict the rules of this filter in the direction
selected.
5. Select Add to apply the filter(s) (and their rules and permissions) to the LAN or WLAN.
6. Click OK add the IP filter to the LAN or WLAN. Navigating away from the screen without clicking
OK results in all changes to the screens being lost.
7. Click Cancel to securely exit the IP Filtering screen without saving your changes.