Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) User Manual
Page 187
Brocade Mobility 7131N-FGR Product Reference Guide
175
53-1001947-01
Configuring firewall settings
6
4. Click Apply to save any changes to the Subnet Access screen. Navigating away from the screen
without clicking the Apply button results in all changes to the screens being lost.
5. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on the Subnet Access screen to the last saved configuration.
6. Click Logout to securely exit the Access Point applet. A prompt displays confirming the logout
before the applet is closed.
Allow or Deny all
protocols, except
Use the drop-down menu to select either Allow or Deny. The
selected setting applies to all protocols except those with enabled
checkboxes and any traffic that is added to the table. For example,
if the adoption rule is to Deny access to all protocols except those
listed, access is allowed only to those selected protocols.
Pre configured Rules
The following protocols are preconfigured with the Brocade
Mobility 7131N-FGR Access Point. To enable a protocol, check the
box next to the protocol name.
•
HTTP - Hypertext Transfer Protocol is the protocol for
transferring files on the Web. HTTP is an application protocol
running on top of the TCP/IP suite of protocols, the
foundation protocols for the Internet. The HTTP protocol uses
TCP port 80.
•
TELNET - TELNET is the terminal emulation protocol of
TCP/IP. TELNET uses TCP to achieve a virtual connection
between server and client, then negotiates options on both
sides of the connection. TELNET uses TCP port 23.
•
FTP - File Transfer Protocol (FTP) is an application protocol
using the Internet's TCP/IP protocols. FTP provides an
efficient way to exchange files between computers on the
Internet. FTP uses TCP port 21.
•
SMTP - Simple Mail Transfer Protocol is a TCP/IP protocol for
sending and receiving email. Due to its limited ability to
queue messages at the receiving end, SMTP is often used
with POP3 or IMAP. SMTP sends the email, and POP3 or IMAP
receives the email. SMTP uses TCP port 25.
•
POP - Post Office Protocol is a TCP/IP protocol intended to
permit a workstation to dynamically access a maildrop on a
server host. A workstation uses POP3 to retrieve email that
the server is holding for it.
•
DNS - Domain Name Service protocol searches for resources
using a database distributed among different name servers.
Add
Click Add to create a new table entry.
Del (Delete)
Click Del (Delete) to remove a selected list entry.
Name
Specify a name for a newly configured protocol.
Transport
Select a protocol from the drop-down menu. For a detailed
description of the protocols available, see
Start Port
Enter the starting port number for a range of ports. If the protocol
uses a single port, enter that port in this field.
End Port
Enter the ending port number for a port range. If the protocol uses
a single port, leave the field blank. A new entry might use Web
Traffic for its name, TCP for its protocol, and 80 for its port number.