Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 98)

86 Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
Configuring SNMP settings
4
6. Click Apply to save any changes to the SNMP Traps screen. Navigating away from the screen
without clicking the Apply button results in all changes to the screen being lost.
7. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on SNMP Traps screen to the last saved configuration.
8. Click Logout to securely exit the Brocade Mobility 7131N-FGR Access Point Access Point
applet. A prompt displays confirming the logout before the applet is closed.
Configuring SNMP RF trap thresholds
Use the SNMP RF Trap Threshold screen as a means to track RF activity and the Brocade Mobility
7131N-FGR Access Point’s radio and associated MU performance. SNMP RF Traps are sent when
RF traffic exceeds defined limits set in the RF Trap Thresholds field of the SNMP RF Traps screen.
Thresholds are displayed for the Brocade Mobility 7131N-FGR Access Point, WLAN, selected radio
and the associated MU.
To configure specific SNMP RF Traps on the Brocade Mobility 7131N-FGR Access Point:
1. Select System Configuration - > SNMP Access - > SNMP RF Trap Thresholds from the menu
tree.
CAUTION
Ensure IPSec has been properly configured to protect communications with the external SNMP
server. Changes will not be applied otherwise.
System Cold Start Generates a trap when the Brocade Mobility 7131N-FGR Access
Point re-initializes while transmitting, possibly altering the SNMP
agent's configuration or protocol entity implementation.
Configuration Changes Generates a trap whenever changes to the Brocade Mobility
7131N-FGR Access Point’s configuration file are saved.
Rogue AP Detection Generates a trap if a Rogue AP is detected by the Brocade Mobility
7131N-FGR Access Point.
AP Radar Detection Generates a trap if an AP is detected using a form of radar
detection.
WPA Counter Measure Generates a trap if an attack is detected against the WPA Key
Exchange Mechanism.
MU Hotspot Status Generates a trap when a change to the status of MU hotspot
member is detected.
VLAN Generates a trap when a change to a VLAN state is detected.
LAN Monitor Generates a trap when a change to the LAN monitoring state is
detected.