Initially connecting to the access point, Connecting to the access point using the wan port, Connecting to the access point using the lan port – Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) User Manual
Page 52
40
Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
Initially connecting to the access point
3
•
Command Line Interface (CLI) via Serial, Telnet and SSH. The access point CLI is accessed
through the RS232 port, via Telnet or SSH. The CLI follows the same configuration conventions
as the device user interface with a few documented exceptions. For details on using the CLI to
manage the access point, see
•
Config file - Readable text file; Importable/Exportable via SFTP. Configuration settings for an
access point can be downloaded from the current configuration of another access point
meeting the import/export requirements. For information on importing or exporting
configuration files, see
“Importing/exporting configurations”
•
MIB (Management Information Base) accessing the Brocade Mobility 7131N-FGR Access Point
SNMP functions using a MIB Browser.
Initially connecting to the access point
NOTE
The procedures described below assume this is the first time you are connecting to a Brocade
Mobility 7131N-FGR Access Point.
NOTE
The computer being used should be configured to use the same IP address and subnet mask as the
access point.
Connecting to the access point using the WAN port
To initially connect to the access point using the access point’s WAN port:
1. Connect AC power to the access point, as Power-Over-Ether support is not available on the
access point’s WAN (or GE2) port.
2. Start a browser and enter the access point’s static IP address (10.1.1.1). The default password
is “admin123.”
3. Refer to
on page 41 for instructions on the initial (basic) configuration of
the access point.
Connecting to the access point using the LAN port
To initially connect to the access point using the access point’s LAN port:
1. The LAN (or GE1/POE) port default is set to DHCP. Connect the access point’s GE1/POE port to
a DHCP server.
The access point will receive its IP address automatically.
2. To view the IP address, connect one end of a null modem serial cable to the access point and
the other end to the serial port of a computer running HyperTerminal or similar emulation
program.
3. Configure the following settings:
•
Baud Rate - 19200
•
Data Bits - 8