Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 78)

66 Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
Configuring data access
4
The Access screen also has a new facility allowing customers to create a login message with
customer generated text. When enabled (using either the access point Web UI or CLI), the login
message displays when the user is logging into the access point. If the login message is disabled,
the default login screen displays with no message.
To configure access for the Brocade Mobility 7131N-FGR Access Point:
1. Select System Configuration -> Access from the menu tree.
2. Use the Brocade Mobility 7131N-FGR Access Point Access field checkboxes to enable/disable
the following on the access point’s LAN1, LAN2 or WAN interfaces:
3. Refer to the Applet Timeout field to set an HTTPS timeout interval.
4. Configure the Secure Shell field to set timeout values to reduce network inactivity.
Applet HTTPS (port
443) Select the LAN1, LAN2 and/or WAN checkboxes to enable access
to the Brocade Mobility 7131N-FGR Access Point configuration
applet using a Secure Sockets Layer (SSL) for encrypted HTTP
sessions.
CLI SSH2 (port 22) Select the LAN1, LAN2 and/or WAN checkboxes to enable access
to the Brocade Mobility 7131N-FGR Access Point CLI using the
SSH (Secure Shell) protocol.
SNMP (port 161) Select the LAN1, LAN2 and/or WAN checkboxes to enable access
to the Brocade Mobility 7131N-FGR Access Point configuration
settings from an SNMP-capable client.
HTTP/S Timeout Disables access to the access point if no data activity is detected
over Applet HTTPS (port 443) after the user defined interval.
Default is 0 Mins.