Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 211)

Brocade Mobility 7131N-FGR Product Reference Guide 199
53-1001947-01
Configuring rogue AP detection
6
For more information on the displaying information on detected rogue APs, see “Displaying
rogue AP details” on page 199.
7. To remove the Rogue AP entries displayed within the e Rogue APs field, click the Clear Rogue
AP List button.
Brocade only recommends clearing the list of Rogue APs when the devices displaying within
the list do not represent a threat to the access point managed network.
8. Click Apply to save any changes to the Active APs screen. Navigating away from the screen
without clicking Apply results in all changes to the screen being lost.
9. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on the Active APs screen to the last saved configuration.
10. Click Logout to securely exit the Access Point applet. A prompt displays confirming the logout
before the applet is closed.
Displaying rogue AP details
Before moving a rogue AP into the list of allowed APs within the Active APs screen, the device
address and rogue detection information for that AP should be evaluated.
To evaluate the properties of a rogue AP:
1. Select Network Configuration -> Wireless -> Rogue AP Detection -> Active APs from the
Brocade Mobility 7131N-FGR Access Point menu tree.
2. Highlight a target rogue AP from within Rogue APs table and click the Details button.
The Detail screen displays for the rogue AP.
3. Refer to the Rogue AP Detail field for the following information: