Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 55)

Brocade Mobility 7131N-FGR Product Reference Guide 43
53-1001947-01
Basic configuration
3
Configuring the access point
For the basic setup described in this guide, the Java-based Web UI will be used to configure the
access point. The GE1/POE port’s default setting is static (with a default IP address of
192.168.0.1). For this example, the access point’s WAN interface will be used to connect to the
access point. The default WAN IP address is 10.1.1.1. For optimal viewing of the Web UI, the screen
resolution should be set to 1024 x 768 pixels or greater.
Remember, Internet Explorer and Mozilla Firefox require unique settings be defined in order for the
browser to access the Brocade Mobility 7131N-FGR Access Point GUI applet. For instructions on
configuring these browser settings, see
“Configuring your browser for Brocade Mobility 7131N-FGR
Access Point support” on page 41.
1. Start a browser and enter the following IP address in the address field:
https://10.1.1.1
2. Log in using admin as the default Username and admin123 as the default Password. Use your
new password if it has been updated from default.
NOTE
For optimum compatibility, use Sun Microsystems’ JRE 1.6 or higher (available from Sun’s Website),
and be sure to disable Microsoft’s Java Virtual Machine if installed.
3. If the default login is successful, the Change Admin Password window displays. Change the
password to ensure the Brocade Mobility 7131N-FGR Access Point is using a secure password
different from the default password. The new password must be at least 8 characters in
length.
Enter the current password and a new admin password in fields provided. Click Apply. Once the
admin password has been updated, a warning message displays stating the access point must
be set to a country. Proceed to
“Configuring device settings” on page 44 to validate the country
setting.