Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 449)

Brocade Mobility 7131N-FGR Product Reference Guide 437
53-1001947-01
System commands
8
BR7131N>admin(system.snmp.traps)> set
Sets SNMP trap parameters.
Syntax
For information on configuring SNMP traps using the applet (GUI), see “Configuring specific SNMP
traps” on page 84.
set mu-assoc enable/disable Enables/disables the MU associated trap.
mu-unassoc enable/disable Enables/disables the MU unassociated trap.
mu-deny-assoc enable/disable Enables/disables the MU association denied
trap.
mu-deny-auth enable/disable Enables/disables the MU authentication denied
trap.
snmp-auth enable/disable Enables/disables the authentication failure trap.
snmp-acl enable/disable Enables/disables the SNMP ACL violation trap.
dos-attack enable/disable Enables/disables the denial of service trap.
interval <rate> Sets denial of service trap interval.
cold enable/disable Enables/disables the system cold start trap.
cfg enable/disable Enables/disables a configuration changes trap.
rogue-ap enable/disable Enables/disables a trap when a rogue-ap is
detected.
ap-radar enable/disable Enables/disables the AP Radar Detection trap.
wpa-counter enable/disable Enables/disables the WPA counter measure trap.
hotspot-mu-status enable/disable Enables/disables the hotspot mu status trap.
vlan enable/disable Enables/disables VLAN traps.
lan-monitor enable/disable Enables/disables LAN monitor traps.
rate <rate> <sco
pe> <valu
e> Sets the particular <rate> to monitor to <value>
given the indicated <scope>. See table below for
information on the possible values for <rate>,
<scope>, and <value>.
min-pkt <pkt> Sets the minimum number of packets required
for rate traps to fire (1-65535).
all enable/disable Enables/disables each trap.