Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 255)

Brocade Mobility 7131N-FGR Product Reference Guide 243
53-1001947-01
Viewing known access point statistics
7
“auto-select” and “preferred list” settings. Additionally, LAN1 and LAN2 IP mode settings will only
be sent if the sender’s AP mode is DHCP or BOOTP. The WAN’s IP mode will only be sent if the
sender’s IP mode is DHCP.
6. Click the Start Flash button to flash the LEDs of other Brocade Mobility 7131N-FGR Access
Points detected and displayed within the Known AP Statistics screen.
Use the Start Flash button to determine the location of the devices displayed within the Known
AP Statistics screen. When a Brocade Mobility 7131N-FGR Access Point is highlighted and the
Start Flash button is selected, the LEDs on the selected Brocade Mobility 7131N-FGR Access
Point flash. When the Stop Flash button is selected, the LEDs on the selected Brocade Mobility
7131N-FGR Access Point go back to normal operation.
7. Click the Logout button to securely exit the Access Point applet. A prompt displays confirming
the logout before the applet is closed.