Br7131n>admin(system.snmp.traps)> add – Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) User Manual
Page 450
438
Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
System commands
8
BR7131N>admin(system.snmp.traps)> add
Adds SNMP trap entries.
Syntax
Example
admin(system.snmp.traps)>add v1v2 203.223.24.2 333 mycomm v1
admin(system.snmp.traps)>list v1v2c
----------------------------------------------------------------------
index
dest ip
dest port
community
version
----------------------------------------------------------------------
1
203.223.24.2
333
mycomm
v1
admin(system.snmp.traps)>add v3 201.232.24.33 555 BigBoss none md5
admin(system.snmp.traps)>list v3 all
index
: 1
destination ip
: 201.232.24.33
destination port
: 555
username
: BigBoss
security level
: none
auth algorithm
: md5
auth password
: ********
privacy algorithm
: des
privacy password
: ********
For information on configuring SNMP traps using the applet (GUI), see
ad
d
v1v
2
<ip>
<port>
<comm>
<ver>
Adds an entry to the SNMP v1/v2 access list with the destination IP address set to <ip>, the
destination UDP port set to <port>, the community string set to <comm> (1 to 31 characters), and the
SNMP version set to <ver>.
v3
<ip>
<port>
<user>
<sec>
<auth>
<pass1>
<priv>
<pass2>
Adds an entry to the SNMP v3 access list with the destination IP address set to <ip>, the destination
UDP port set to <port>, the username set to <user> (1 to 31 characters), and the authentication type
set to one of none, auth, or auth/priv.
The following parameters must be specified if <sec> is not none:
Authentication type <auth> set to md5 or sha1
Authentication password <pass1> (8 to 31 chars)
The following parameters must be specified if <sec> is set to auth/priv:
Privacy algorithm set to des or aes
Privacy password <pass2> (8 to 31 chars)