Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 39)

Brocade Mobility 7131N-FGR Product Reference Guide 27
53-1001947-01
Mounting a Brocade Mobility 7131N-FGR Access Point
2
Mounting a Brocade Mobility 7131N-FGR Access Point
A Brocade Mobility 7131N-FGR Access Point can attach to a wall, mount under a suspended T-Bar
or above a ceiling (plenum or attic) following the same installation instructions. Choose one of the
following mounting options based on the physical environment of the coverage area. Do not mount
the access point in a location that has not been approved in a site survey.
Refer to the following, depending on how you intend to mount the access point:
• Wall mounted installations
• Suspended ceiling T-bar installations
• Above the ceiling (plenum) installations
Wall mounted installations
Wall mounting requires hanging the access point along its width (or length) using the pair of slots
on the bottom of the unit and using the access point mounting template for the screws.
CAUTION
An access point should be wall mounted to concrete or plaster-wall-board (dry wall) only. Do not
wall mount an access point to combustible surfaces.
The hardware and tools (customer provided) required to install the access point on a wall consists
of:
• Two Phillips pan head self-tapping screws (ANSI Standard) #6-18 X 0.875in. Type A or AB
Self-Tapping screw, or (ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D Self-Tapping screw
• Two wall anchors
• Wall mount template (included on next page)
• Security cable (optional third part provided accessory)
To mount the access point on a wall using the provided template: