Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 254)

242 Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
Viewing known access point statistics
7
The Known AP Details screen displays the target AP’s MAC address, IP address, radio channel,
number of associated MUs, packet throughput per second, radio type(s), model, firmware
version, ESS and client bridges currently connected to the AP radio. Use this information to
determine whether this AP provides better MU association support than the locating access
point or warrants consideration as a member of a different mesh network.
4. Click the Ping button to display a screen for verifying the link with a highlighted access point.
NOTE
A ping test initiated from the Brocade Mobility 7131N-FGR Access Point Known AP Statistics
screen uses WNMP pings. Therefore, target devices that are not Brocade access points are
unable to respond to the ping test.
5. Click the Send Cfg to APs button to send the your access point’s configuration to other access
point’s. The recipient access point must be the same single or dual-radio model as the access
point sending the configuration. The sending and recipient access point’s must also be running
the same major firmware version.
CAUTION
When using the Send Cfg to APs function to migrate an access point’s configuration to other
access points, it is important to keep in mind mesh network configuration parameters do not get
completely sent to other access points. The Send Cfg to APs function will not send the