Kontron AT890X Full-Size CLI - Manual (Page 104)

Switching Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 2 - 70
Format
lldp notification-interval <interval>
Mode Global Config
2.17.7.1 no lldp notification-interval
Use this command to return the notification interval to the default value.
Format no lldp notification-interval
Mode Global Config
2.17.8 clear lldp statistics
Use this command to reset all LLDP statistics.
Format
clear lldp statistics
Mode Global Config
2.17.9 clear lldp remote-data
Use this command to delete all information from the LLDP remote data table.
Format
clear lldp remote-data
Mode Global Config
2.17.10 show lldp
Use this command to display a summary of the current LLDP configuration.
Format show lldp
Mode Privileged EXEC
Transmit Interval Shows how frequently the system transmits local data LLDPDUs,
in seconds.
Transmit Hold Multiplier Shows the multiplier on the transmit interval that sets the
TTL in local data LLDPDUs.
Re-initialization Delay Shows the delay before re-initialization, in seconds.
Notification Interval Shows how frequently the system sends remote data change
notifications, in seconds.
2.17.11 show lldp interface
Use this command to display a summary of the current LLDP configuration for a
specific interface or for all interfaces.
Format
show lldp interface {<unit/slot/port> | all}
Mode Privileged EXEC.
Interface Shows the interface in a unit/slot/port format.
Link Shows whether the link is up or down.
Transmit Shows whether the interface transmits LLDPDUs.
Receive Shows whether the interface receives LLDPDUs.