Kontron AT890X Full-Size CLI - Manual (Page 172)

Quality of Service (QoS) Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 4 - 6
4.1.10 show classofservice ip-dscp-mapping
This command displays the current IP DSCP mapping to internal traffic classes for the
global configuration settings.
Format show classofservice ip-dscp-mapping
Mode Privileged EXEC
The following information is repeated for each user priority.
IP DSCP The IP DSCP value.
Traffic Class The traffic class internal queue identifier to which the IP DSCP value
is mapped.
4.1.11 show classofservice trust
This command displays the current trust mode setting for a specific interface. The
< unit/slot/port > parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If you specify an interface, the
command displays the port trust mode of the interface. If you do not specify an
interface, the command displays the most recent global configuration settings.
Format show classofservice trust [<unit/slot/port>]
Mode Privileged EXEC
Non-IP Traffic Class The traffic class used for non-IP traffic. This is only displayed
when the COS trust mode is set to trust IP Precedence or IP DSCP (on
platforms that support IP DSCP).
Untrusted Traffic Class The traffic class used for all untrusted traffic. This is only
displayed when the COS trust mode is set to 'untrusted'.
4.1.12 show interfaces cos-queue
This command displays the class-of-service queue configuration for the specified
interface. The unit/slot/port parameter is optional and is only valid on platforms that
support independent per-port class of service mappings. If specified, the class-of-
service queue configuration of the interface is displayed. If omitted, the most recent
global configuration settings are displayed.
Format
show interfaces cos-queue [<unit/slot/port>]
Mode Privileged EXEC
Queue Id An interface supports n queues numbered 0 to (n-1). The specific n
value is platform dependent.
Minimum Bandwidth The minimum transmission bandwidth guarantee for the
queue, expressed as a percentage. A value of 0 means bandwidth is not
guaranteed and the queue operates using best-effort. This is a config-
ured value.
Scheduler Type Indicates whether this queue is scheduled for transmission using a
strict priority or a weighted scheme. This is a configured value.
Queue Management Type The queue depth management technique used for this
queue (tail drop).