Kontron AT890X Full-Size CLI - Manual (Page 244)

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 2
6. Management Commands
This chapter describes the management commands available in the CLI.
The Management Commands chapter contains the following sections:
• 6.1 “Network Interface Commands” on page 6 - 2
• 6.2 “Console Port Access Commands” on page 6 - 5
• 6.3 “Telnet Commands” on page 6 - 7
• 6.4 “Secure Shell (SSH) Command” on page 6 - 11
• 6.5 “User Account Commands” on page 6 - 13
• 6.6 “SNMP Commands” on page 6 - 16
• 6.7 “CLI Command Logging Command” on page 6 - 24
• 6.8 “RADIUS Commands” on page 6 - 25
• 6.9 “TACACS+ Commands” on page 6 - 30
• 6.10 “Configuration Scripting Commands” on page 6 - 33
• 6.11 “Pre-login Banner and System Prompt Commands” on page 6 - 35
• 6.12 “Watchdog support” on page 6 - 35
• 6.13 “ASI commands” on page 6 - 36
The commands in this chapter are divided into three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.
• Copy commands transfer or save configuration and informational files to and from
the switch.
6.1 Network Interface Commands
This section describes the commands you use to configure a logical interface for
management access. To configure the management VLAN, see 2.3.2 “network
mgmt_vlan” on page 2 - 17
6.1.1 enable (Privileged EXEC access)
This command gives you access to the Privileged EXEC mode. From the Privileged
EXEC mode, you can configure the network interface.
Format
enable
Mode User EXEC
6.1.2 serviceport ip
This command sets the IP address, the netmask and the gateway of the network
management port.
Format serviceport ip <ipaddr> <netmask> [gateway]
Mode Privileged EXEC