Kontron AT890X Full-Size CLI - Manual (Page 231)

AT8901/2/3 Utility Commands
Page 5 - 33 AT8901/2/3 CLI Reference Manual
5.9.1.1 no ip dhcp pool
This command removes the DHCP address pool. The name should be previously
configured pool name.
Format no ip dhcp pool <name>
Mode Global Config
5.9.2 client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a
valid notation in hexadecimal format. In some systems, such as Microsoft DHCP
clients, the client identifier is required instead of hardware addresses. The unique-
identifier is a concatenation of the media type and the MAC address. For example, the
Microsoft client identifier for Ethernet address c819.2488.f177 is 01c8.1924.88f1.77
where 01 represents the Ethernet media type. For more information, refer to the
“Address Resolution Protocol Parameters” section of RFC 1700, Assigned Numbers
for a list of media type codes.
Default none
Format
client-identifier <uniqueidentifier>
Mode DHCP Pool Config
5.9.2.1 no client-identifier
This command deletes the client identifier.
Format no client-identifier
Mode DHCP Pool Config
5.9.3 client-name
This command specifies the name for a DHCP client. Name is a string consisting of
standard ASCII characters.
Default none
Format
client-name <name>
Mode DHCP Pool Config
5.9.3.1 no client-name
This command removes the client name.
Format no client-name
Mode DHCP Pool Config
5.9.4 default-router
This command specifies the default router list for a DHCP client. {
address1,
address2… address8 } are valid IP addresses, each made up of four decimal bytes
ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default none