Kontron AT890X Full-Size CLI - Manual (Page 126)

Routing Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 14
RIP This field displays the RIP route preference value.
BGP4 This field displays the BGP-4 route preference value.
NOTE: The configuration of NSSA preferences is not supported in this
release.
3.2.17 show ip stats
This command displays IP statistical information. Refer to RFC 1213 for more
information about the fields that are displayed.
Format
show ip stats
Modes Privileged EXEC
User EXEC
3.3 Router Discovery Protocol Commands
This section describes the commands you use to view and configure Router Discovery
Protocol settings on the switch. The Router Discovery Protocol enables a host to
discover the IP address of routers on the subnet.
3.3.1 ip irdp
This command enables Router Discovery on an interface.
Default disabled
Format
ip irdp
Mode Interface Config
3.3.1.1 no ip irdp
This command disables Router Discovery on an interface.
Format
no ip irdp
Mode Interface Config
3.3.2 ip irdp address
This command configures the address that the interface uses to send the router
discovery advertisements. The valid values for
<ipaddr> are 224.0.0.1, which is the
all-hosts IP multicast address, and 255.255.255.255, which is the limited broadcast
address.
Default 224.0.0.1
Format ip irdp address <ipaddr>
Mode Interface Config
3.3.2.1 no ip irdp address
This command configures the default address used to advertise the router for the
interface.