Kontron AT890X Full-Size CLI - Manual (Page 39)

AT8901/2/3 Switching Commands
Page 2 - 5 AT8901/2/3 CLI Reference Manual
2.1.9 speed all
This command sets the speed and duplex setting for all interfaces.
Format
speed all {<100 | 10> <half-duplex | full-duplex>}
Mode Global Config
Acceptable values are:
100h 100BASE-T half-duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 10BASE-T full duplex
2.1.10 show port
This command displays port information.
Format
show port {<unit/slot/port> | all}
Mode Privileged EXEC
Interface Valid slot and port number separated by forward slashes.
Type If not blank, this field indicates that this port is a special type of port.
The possible values are:
Mirror - this port is a monitoring port. For more information, see 2.13
“Port Mirroring” on page 2 - 56.
PC Mbr- this port is a member of a port-channel (LAG).
Probe - this port is a probe port.
Admin Mode Selects the Port control administration state. The port must be enabled
in order for it to be allowed into the network. - May be enabled or dis-
abled. The factory default is enabled.
Physical Mode Selects the desired port speed and duplex mode. If auto-negotiation
support is selected, then the duplex mode and speed is set from the
auto-negotiation process. Note that the maximum capability of the port
(full duplex -100M) is advertised. Otherwise, this object determines
the port's duplex mode and transmission rate. The factory default is
Auto.
Physical Status Indicates the port speed and duplex mode.
Link Status Indicates whether the Link is up or down.
Link Trap
This object determines whether or not to send a trap when link status
changes. The factory default is enabled.
LACP Mode Displays whether LACP is enabled or disabled on this port.
2.1.11 show port protocol
This command displays the Protocol-Based VLAN information for either the entire
system, or for the indicated group.
Format
show port protocol {<groupid> | all}