Kontron AT890X Full-Size CLI - Manual (Page 169)

AT8901/2/3 Quality of Service (QoS) Commands
Page 4 - 3 AT8901/2/3 CLI Reference Manual
4.1.2 classofservice ip-precedence-mapping
This command maps an IP precedence value to an internal traffic class. The
<ip-
precedence>
values can range from 0-7. The
<trafficclass>
values can range from
0-6, although the actual number of available traffic classes depends on the platform.
Format classofservice ip-precedence-mapping <ip-precedence>
<trafficclass>
Modes Global Config
Interface Config
4.1.2.1 no classofservice ip-precedence-mapping
This command maps each IP precedence value to its default internal traffic class value.
Format
no classofservice ip-precedence-mapping
Modes Global Config
Interface Config
4.1.3 classofservice ip-dscp-mapping
This command maps an IP DSCP value to an internal traffic class. The
<ipdscp>
value is specified as either an integer from 0 to 63, or symbolically through one of the
following keywords:
af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1,
cs2, cs3, cs4, cs5, cs6, cs7, ef .
The <trafficclass> values can range from 0-6, although the actual number of
available traffic classes depends on the platform.
Format
classofservice ip-dscp-mapping <ipdscp> <trafficclass>
Mode Global Config
4.1.3.1 no classofservice ip-dscp-mapping
This command maps each IP DSCP value to its default internal traffic class value.
Format no classofservice ip-dscp-mapping
Mode Global Config
4.1.4 classofservice trust
This command sets the class of service trust mode of an interface. You can set the
mode to trust one of the Dot1p (802.1p), IP DSCP, or IP Precedence packet markings.
You can also set the interface mode to untrusted. If you configure an interface to use
Dot1p, the mode does not appear in the output of the
show running config
command
because Dot1p is the default.
NOTE: The classofservice trust dot1p command will not be supported
in future releases of the software because Dot1p is the default value.
Use the
no classofservice trust command to set the mode to the
default value.