Kontron AT890X Full-Size CLI - Manual (Page 227)

AT8901/2/3 Utility Commands
Page 5 - 29 AT8901/2/3 CLI Reference Manual
5.8.1 sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power
of two where <poll-interval> can be a value from 6 to 16.
Default 6
Format sntp broadcast client poll-interval <poll-interval>
Mode Global Config
5.8.1.1 no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default
value.
Format
no sntp broadcast client poll-interval
Mode Global Config
5.8.2 sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and may
set the mode to either broadcast or unicast.
Default disabled
Format
sntp client mode [broadcast | unicast]
Mode Global Config
5.8.2.1 no sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
Format.
no sntp client mode
Mode Global Config
5.8.3 sntp client port
This command sets the SNTP client port id to a value from 1-65535.
Default 123
Format sntp client port <portid>
Mode Global Config
5.8.3.1 no sntp client port
This command resets the SNTP client port back to its default value.
Format.
no sntp client port
Mode Global Config
5.8.4 sntp unicast client poll-interval
This command sets the poll interval for SNTP unicast clients in seconds as a power of
two where <poll-interval> can be a value from 6 to 16.