Kontron AT890X Full-Size CLI - Manual (Page 269)

AT8901/2/3 Management Commands
Page 6 - 27 AT8901/2/3 CLI Reference Manual
Format
no radius server msgauth <ipaddr>
Mode Global Config
6.8.5 radius server primary
This command is used to configure the primary RADIUS authentication server for this
RADIUS client. The primary server handles RADIUS requests. The remaining
configured servers are only used if the primary server cannot be reached. You can
configure up to three servers on each client. Only one of these servers can be
configured as the primary. If a primary server is already configured prior to this
command being executed, the server specified by the IP address specified used in this
command will become the new primary server. The IP address must match that of a
previously configured RADIUS authentication server.
Format radius server primary <ipaddr>
Mode Global Config
6.8.6 radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted
when no response is received from the RADIUS server. The retries value is an integer
in the range of 1 to 15.
Default 4
Format
radius server retransmit <retries>
Mode Global Config
6.8.6.1 no radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted, to
the default value.
Format
no radius server retransmit
Mode Global Config
6.8.7 radius server timeout
This command sets the timeout value (in seconds) after which a request must be
retransmitted to the RADIUS server if no response is received. The timeout value is an
integer in the range of 1 to 30.
Default 5
Format radius server timeout <seconds>
Mode Global Config
6.8.7.1 no radius server timeout
This command sets the timeout value to the default value.
Format
no radius server timeout
Mode Global Config