Kontron AT890X Full-Size CLI - Manual (Page 146)

Routing Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 34
3.7.31 ip ospf hello-interval
This command sets the OSPF hello interval for the specified interface. The value for
seconds is a valid positive integer, which represents the length of time in seconds. The
value for the length of time must be the same for all routers attached to a network.
Valid values range from 1 to 65535.
Default 10
Format
ip ospf hello-interval <seconds>
Mode Interface Config
3.7.31.1 no ip ospf hello-interval
This command sets the default OSPF hello interval for the specified interface.
Format no ip ospf hello-interval
Mode Interface Config
3.7.32 ip ospf priority
This command sets the OSPF priority for the specified router interface. The priority of
the interface is a priority integer from 0 to 255. A value of 0 indicates that the router is
not eligible to become the designated router on this network.
Default 1, which is the highest router priority.
Format
ip ospf priority <0-255>
Mode Interface Config
3.7.32.1 no ip ospf priority
This command sets the default OSPF priority for the specified router interface.
Format no ip ospf priority
Mode Interface Config
3.7.33 ip ospf retransmit-interval
This command sets the OSPF retransmit Interval for the specified interface. The
retransmit interval is specified in seconds. The value for <
seconds > is the number of
seconds between link-state advertisement retransmissions for adjacencies belonging to
this router interface. This value is also used when retransmitting database description
and link-state request packets. Valid values range from 0 to 3600 (1 hour).
Default 5
Format
ip ospf retransmit-interval <0-3600>
Mode Interface Config
3.7.33.1 no ip ospf retransmit-interval
This command sets the default OSPF retransmit Interval for the specified interface.
Format
no ip ospf retransmit-interval