Kontron AT890X Full-Size CLI - Manual (Page 235)

AT8901/2/3 Utility Commands
Page 5 - 37 AT8901/2/3 CLI Reference Manual
• p-node—Peer-to-peer
• m-node—Mixed
• h-node—Hybrid (recommended)
Default none
Format netbios-node-type <type>
Mode DHCP Pool Config
5.9.13.1 no netbios-node-type
This command removes the NetBIOS node Type.
Format
no netbios-node-type
Mode DHCP Pool Config
5.9.14 next-server
This command configures the next server in the boot process of a DHCP client.The
<address>
parameter is the IP address of the next server in the boot process, which is
typically a TFTP server.
Default inbound interface helper addresses
Format
next-server <address>
Mode DHCP Pool Config
5.9.14.1 no next-server
This command removes the boot server list.
Format
no next-server
Mode DHCP Pool Config
5.9.15 option
The
option
command configures DHCP Server options. The <
code
> parameter
specifies the DHCP option code and ranges from 1-254. The
<ascii string>
parameter specifies an NVT ASCII character string. ASCII character strings that
contain white space must be delimited by quotation marks. The
hex <string>
parameter specifies hexadecimal data. In hexadecimal, character strings are two
hexadecimal digits. You can separate each byte by a period (for example, a3.4f.22.0c),
colon (for example, a3:4f:22:0c), or white space (for example, a3 4f 22 0c).
Default none
Format option <code> {ascii string | hex <string1>
[<string2>...<string8>] | ip <address1>
[<address2>...<address8>]}
Mode DHCP Pool Config
5.9.15.1 no option
This command removes the DHCP Server options. The <
code
> parameter specifies the
DHCP option code.