Kontron AT890X Full-Size CLI - Manual (Page 171)

AT8901/2/3 Quality of Service (QoS) Commands
Page 4 - 5 AT8901/2/3 CLI Reference Manual
4.1.7 traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface
as a whole. Also known as rate shaping, traffic shaping has the effect of smoothing
temporary traffic bursts over time so that the transmitted traffic rate is bounded.
Format traffic-shape <bw>
Modes Global Config
Interface Config
4.1.7.1 no traffic-shape
This command restores the interface shaping rate to the default value.
Format
no traffic-shape
Modes Global Config
Interface Config
4.1.8 show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic
classes for a specific interface. The
< unit/slot/port > parameter is optional and is only
valid on platforms that support independent per-port class of service mappings. If
specified, the 802.1p mapping table of the interface is displayed. If omitted, the most
recent global configuration settings are displayed. For more information, see 2.5
“Provisioning (IEEE 802.1p) Commands” on page 2 - 29.
Format show classofservice dot1p-mapping [<unit/slot/port>]
Mode Privileged EXEC
The following information is repeated for each user priority.
User Priority The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which the user priority
value is mapped.
4.1.9 show classofservice ip-precedence-mapping
This command displays the current IP Precedence mapping to internal traffic classes
for a specific interface. The unit/slot/port parameter is optional and is only valid on
platforms that support independent per-port class of service mappings. If specified, the
IP Precedence mapping table of the interface is displayed. If omitted, the most recent
global configuration settings are displayed.
Format
show classofservice ip-precedence-mapping [<unit/slot/
port>]
Mode Privileged EXEC
The following information is repeated for each user priority.
IP Precedence The IP Precedence value.
Traffic Class The traffic class internal queue identifier to which the IP Precedence
value is mapped.