Kontron AT890X Full-Size CLI - Manual (Page 87)

AT8901/2/3 Switching Commands
Page 2 - 53 AT8901/2/3 CLI Reference Manual
Mode Interface Config
2.12.3 deleteport (Interface Config)
This command deletes the port from the port-channel (LAG). The interface is a Logical
slot and port number. of a configured port-channel.
Format
deleteport <logical unit/slot/port>
Mode Interface Config
2.12.4 deleteport (Global Config)
This command deletes all configured ports from the port-channel (LAG). The interface
is a Logical slot and port number. of a configured port-channel. To clear the port
channels, see 5.6.6 “clear port-channel” on page 5 - 24
Format
deleteport {<logical unit/slot/port> | all}
Mode Global Config
2.12.5 port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default
the static mode for a new port-channel is disabled, which means the port-channel is
dynamic. However if the maximum number of allowable dynamic port-channels are
already present in the system, the static mode for a new port-channel enabled, which
means the port-channel is static.You can only use this command on port-channel
interfaces.
Default disabled
Format
port-channel static
Mode Interface Config
2.12.5.1 no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the
default value. This command will be executed only for interfaces of type port-channel
(LAG).
Format
no port-channel static
Mode Interface Config
2.12.6 port lacpmode
This command enables Link Aggregation Control Protocol (LACP) on a port.
Default enabled
Format port lacpmode
Mode Interface Config
2.12.6.1 no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.