Kontron AT890X Full-Size CLI - Manual (Page 97)

AT8901/2/3 Switching Commands
Page 2 - 63 AT8901/2/3 CLI Reference Manual
Format
no set igmp mrouter <vlanid>
Mode Interface Config
2.15.8 set igmp mrouter interface
This command configures the interface as a multicast router interface. When
configured as a multicast router interface, the interface is treated as a multicast router
interface in all VLANs.
Default disabled
Format
set igmp mrouter interface
Mode Interface Config
2.15.8.1 no set igmp mrouter interface
This command disables the status of the interface as a statically configured multicast
router interface.
Format
no set igmp mrouter interface
Mode Interface Config
2.15.9 show igmpsnooping
This command displays IGMP Snooping information. Configured information is
displayed whether or not IGMP Snooping is enabled.
Format
show igmpsnooping [<unit/slot/port> | <vlanid>]
Mode Privileged EXEC
When the optional arguments
<
unit/slot/port
>
or
<vlanid>
are not used, the command
displays the following information:
Admin Mode This indicates whether or not IGMP Snooping is active on the switch.
Interfaces Enabled for IGMP Snooping Interfaces on which IGMP Snooping is
enabled.
Multicast Control Frame Count This displays the number of multicast control
frames that are processed by the CPU.
VLANS Enabled for IGMP Snooping VLANS on which IGMP Snooping is
enabled.
When you specify the
<
unit/slot/port> values, the following information displays:
IGMP Snooping Admin Mode ndicates whether IGMP Snooping is active on the
interface.
Fast Leave Mode Indicates whether IGMP Snooping Fast-leave is active on the
VLAN.
Group Membership Interval Shows the amount of time in seconds that a switch will
wait for a report from a particular group on a particular interface,
which is participating in the VLAN, before deleting the interface from
the entry.This value may be configured