Kontron AT890X Full-Size CLI - Manual (Page 116)

Routing Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 4
3.1.5 arp purge
This command causes the specified IP address to be removed from the ARP cache.
Only entries of type dynamic or gateway are affected by this command.
Format arp purge <ipaddr>
Mode Privileged EXEC
3.1.6 arp resptime
This command configures the ARP request response timeout.
The value for <seconds> is a valid positive integer, which represents the IP ARP entry
response timeout time in seconds. The range for
<seconds>
is between 1-10 seconds.
Default l
Format arp resptime <1-10>
Mode Global Config
3.1.6.1 no arp resptime
This command configures the default ARP request response timeout.
Format
no arp resptime
Mode Global Config
3.1.7 arp retries
This command configures the ARP count of maximum request for retries.
The value for
<retries>
is an integer, which represents the maximum number of
request for retries. The range for
<retries>
is an integer between 0-10 retries.
Default 4
Format
arp retries <0-10>
Mode Global Config
3.1.7.1 no arp retries
This command configures the default ARP count of maximum request for retries.
Format
no arp retries
Mode Global Config
3.1.8 arp timeout
This command configures the ARP entry ageout time.
The value for
<seconds>
is a valid positive integer, which represents the IP ARP entry
ageout time in seconds. The range for <seconds> is between 15-21600 seconds.
Default 1200
Format
arp timeout <15-21600>