Kontron AT890X Full-Size CLI - Manual (Page 76)

Switching Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 2 - 42
Format
dot1x timeout {{reauth-period <seconds>} | {quiet-period
<seconds>} | {tx-period <seconds>} | {supp-timeout <sec-
onds>} | {server-timeout <seconds>}}
Mode Interface Config
2.10.13.1 no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state
machine on this port to the default values. Depending on the token used, the
corresponding default values are set.
Format no dot1x timeout {reauth-period | quiet-period | tx-period
| supp-timeout | server-timeout}
Mode Interface Config
2.10.14 dot1x user
This command adds the specified user to the list of users with access to the specified
port or all ports. The
<user>
parameter must be a configured user.
Format
dot1x user <user> {<unit/slot/port> | all}
Mode Global Config
2.10.14.1 no dot1x user
This command removes the user from the list of users with access to the specified port
or all ports.
Format
no dot1x user <user> {<unit/slot/port> | all}
Mode Global Config
2.10.15 users defaultlogin
This command assigns the authentication login list to use for non-configured users
when attempting to log in to the system. This setting is overridden by the
authentication login list assigned to a specific user if the user is configured locally. If
this value is not configured, users will be authenticated using local authentication only.
Format users defaultlogin <listname>
Mode Global Config
2.10.16 users login
This command assigns the specified authentication login list to the specified user for
system login. The
<user> must be a configured <user> and the <listname> must be
a configured login list.
If the user is assigned a login list that requires remote authentication, all access to the
interface from all CLI, web, and telnet sessions will be blocked until the authentication
is complete.
Note that the login list associated with the ‘admin’ user can not be changed to prevent
accidental lockout from the switch.