2 macfilter addsrc, 3 macfilter addsrc all – Kontron AT890X Full-Size CLI User Manual
Page 92
Switching Commands
AT8901/2/3
AT8901/2/3 CLI Reference Manual
Page 2 - 58
01:80:C2:00:00:21, and FF:FF:FF:FF:FF:FF. The <
vlanid
> parameter must identify a
valid VLAN. You can create up to 100 static MAC filters.
Format
macfilter <macaddr> <vlanid>
Mode
Global Config
2.14.1.1
no macfilter
This command removes all filtering restrictions and the static MAC filter entry for the
MAC address
<macaddr>
on the VLAN
<vlanid>
. The
<macaddr>
parameter must be
specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The
<vlanid>
parameter must identify a valid VLAN.
Format
no macfilter <macaddr> <vlanid>
Mode
Global Config
2.14.2
macfilter addsrc
This command adds the interface to the source filter set for the MAC filter with the
MAC address of <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must
be specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The
<vlanid>
parameter must identify a valid VLAN.
Format
macfilter addsrc <macaddr> <vlanid>
Mode
Interface Config
2.14.2.1
no macfilter addsrc
This command removes a port from the source filter set for the MAC filter with the
MAC address of
<macaddr>
and VLAN of
<vlanid>
. The <macaddr> parameter
must be specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The
<vlanid>
parameter must identify a valid VLAN.
Format
no macfilter addsrc <macaddr> <vlanid>
Mode
Interface Config
2.14.3
macfilter addsrc all
This command adds all interfaces to the source filter set for the MAC filter with the
MAC address of
<macaddr>
and
<vlanid>
. You must specify the
<macaddr>
parameter as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The
<vlanid>
parameter must identify a valid VLAN.
Format
macfilter addsrc all <macaddr> <vlanid>
Mode
Global Config
2.14.3.1
no macfilter addsrc all
This command removes all interfaces to the source filter set for the MAC filter with the
MAC address of
<macaddr>
and VLAN of
<vlanid>
. You must specify the
<macaddr>
parameter as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The
<vlanid>
parameter must identify a valid VLAN.