Kontron AT890X Full-Size CLI - Manual (Page 130)

Routing Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 18
interface. The parameter
<vrid>
is the virtual router ID which has an integer value
range from 1 to 255.
Default none
Format
ip vrrp <vrid>
Mode Global Config
Interface Config
3.5.1.1 no ip vrrp
In Global Config mode, this command disables the default administrative mode of
VRRP in the router. In Interface Config mode, this command disables the VRRP
protocol on an interface. This command also removes a virtual router IP address as a
secondary IP address on an interface. The virtual Router ID,
<vrid>
, is an integer value
that ranges from 1 to 255.
Format
no ip vrrp <vrid> <ipaddress> [secondary]
Mode Global Config
Interface Config
3.5.2 ip vrrp mode
This command enables the virtual router configured on the specified interface.
Enabling the status field starts a virtual router. The parameter
<vrid>
is the virtual
router ID which has an integer value ranging from 1 to 255.
Default disabled
Format
ip vrrp <vrid> mode
Mode Interface Config
3.5.2.1 no ip vrrp mode
This command disables the virtual router configured on the specified interface.
Disabling the status field stops a virtual router.
Format no ip vrrp <vrid> mode
Mode Interface Config
3.5.3 ip vrrp ip
This command sets the virtual router ipaddress value for an interface. The value for
<ipaddr> is the IP Address which is to be configured on that interface for VRRP. The
parameter <vrid> is the virtual router ID which has an integer value range from 1 to
255. You can use the optional
[secondary]
parameter to designate the IP address as a
secondary IP address.
Default none
Format ip vrrp <vrid> ip <ipaddr> [secondary]
Mode Interface Config