Kontron AT890X Full-Size CLI - Manual (Page 266)

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 24
Format
show snmptrap
Mode Privileged EXEC
SNMP Trap Name The community string of the SNMP trap packet sent to the trap
manager. The string is case sensitive and can be up to 16 alphanumeric
characters.
IP Address The IP address to receive SNMP traps from this device.
Status Indicates the receiver's status (enabled or disabled).
6.6.24 show trapflags
This command displays trap conditions. Configure which traps the switch should
generate by enabling or disabling the trap condition. If a trap condition is enabled and
the condition is detected, the SNMP agent on the switch sends the trap to all enabled
trap receivers. You do not have to reset the switch to implement the changes. Cold and
warm start traps are always generated and cannot be disabled.
Format
show trapflags
Mode Privileged EXEC
Authentication Flag Can be enabled or disabled. The factory default is enabled. Indi-
cates whether authentication failure traps will be sent.
Link Up/Down Flag Can be enabled or disabled. The factory default is enabled. Indi-
cates whether link status traps will be sent.
Multiple Users Flag Can be enabled or disabled. The factory default is enabled. Indi-
cates whether a trap will be sent when the same user ID is logged into
the switch more than once at the same time (either through Telnet or
the serial port).
Spanning Tree Flag Can be enabled or disabled. The factory default is enabled. Indi-
cates whether spanning tree traps are sent.
Broadcast Storm Flag Can be enabled or disabled. The factory default is enabled.
Indicates whether broadcast storm traps are sent.
ACL Traps May be enabled or disabled. The factory default is disabled. Indicates
whether ACL traps are sent.
BGP4 Traps Can be enabled or disabled. The factory default is disabled. Indicates
whether BGP4 traps are sent.DVMRP Traps Can be enabled or disabled. The factory
default is disabled. Indicates whether DVMRP traps are sent.
OSPF Traps Can be enabled or disabled. The factory default is disabled. Indicates
whether OSPF traps are sent. PIM Traps Can be enabled or disabled. The factory
default is disabled. Indicates whether PIM traps are sent.
6.7 CLI Command Logging Command
This section describes the commands you use to configure CLI Command Logging.