Kontron AT890X Full-Size CLI - Manual (Page 164)

Routing Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 52
3.8.16 show ip rip interface brief
This command displays general information for each RIP interface. For this command
to display successful results routing must be enabled per interface (i.e. ip rip).
Format show ip rip interface brief
Modes Privileged EXEC
User EXEC
Interface Valid slot and port number separated by forward slashes.
IP Address The IP source address used by the specified RIP interface.
Send Version The RIP version(s) used when sending updates on the specified inter-
face. The types are none, RIP-1, RIP-1c, RIP-2.
Receive Version The RIP version(s) allowed when receiving updates from the speci-
fied interface. The types are none, RIP-1, RIP-2, Both
RIP Mode RIP administrative mode of router RIP operation; enable activates,
disable de-activates it.
Link State The mode of the interface (up or down).
3.8.17 show ip rip interface
This command displays information related to a particular RIP interface.
Format
show ip rip interface <unit/slot/port>
Modes Privileged EXEC
User EXEC
Interface Valid slot and port number separated by forward slashes. This is a con-
figured value.
IP Address The IP source address used by the specified RIP interface. This is a
configured value.
Send version The RIP version(s) used when sending updates on the specified inter-
face. The types are none, RIP-1, RIP-1c, RIP-2. This is a configured
value.
Receive version The RIP version(s) allowed when receiving updates from the speci-
fied interface. The types are none, RIP-1, RIP-2, Both. This is a con-
figured value.
Both RIP Admin Mode RIP administrative mode of router RIP operation; enable
activates, disable de-activates it. This is a configured value.
Link State Indicates whether the RIP interface is up or down. This is a configured
value.
Authentication Type The RIP Authentication Type for the specified interface. The
types are none, simple, and encrypt. This is a configured value.
Default Metric A number which represents the metric used for default routes in RIP
updates originated on the specified interface. This is a configured
value.
The following information will be invalid if the link state is down.