Kontron AT890X Full-Size CLI - Manual (Page 195)

AT8901/2/3 Quality of Service (QoS) Commands
Page 4 - 29 AT8901/2/3 CLI Reference Manual
4.8.1.1 no access-list
This command deletes an IP ACL that is identified by the parameter
<
accesslistnumber>
from the system. The range for <
accesslistnumber>
1-99 for
standard access lists and 100-199 for extended access lists.
Format no access-list <accesslistnumber>
Mode Global Config
4.8.2 ip access-group
This command attaches a specified IP ACL to one interface or to all interfaces.
An optional sequence number may be specified to indicate the order of this IP access
list relative to other IP access lists already assigned to this interface and direction. A
lower number indicates higher precedence order. If a sequence number is already in
use for this interface and direction, the specified access list replaces the currently
attached IP access list using that sequence number. If the sequence number is not
specified for this command, a sequence number that is one greater than the highest
sequence number currently in use for this interface and direction is used.
Default none
Format ip access-group <accesslistnumber> in [sequence <1-
4294967295>]
Modes Interface Config
Global Config
4.8.2.1 no ip access-group
This command removes a specified IP ACL from an interface.
Default none
Format no ip access-group <accesslistnumber> in
Mode Interface Config
4.8.3 acl-trapflags
This command enables the ACL trap mode.
Default disabled
Format
acl-trapflags
[assign-queue <queue-id>] Specifies the assign-queue, which is the queue identifier to
which packets matching this rule are assigned.
[{mirror | redirect}
<unit/slot/port>] For Broadcom 5650x platforms, specifies the mirror or redirect
interface which is the unit/slot/port to which packets matching
this rule are copied or forwarded, respectively. The
mirror
and redirect parameters are not available on the Broadcom
5630x platform.
Table 2. ACL Command Parameters
Parameter Description